Some Useful Tips to Ensure Right Roof Installation

Some Useful Tips to Ensure Right Roof Installation


If you are looking for an affordable and feasible roof replacement option for your home, you must stick your choice with Plywood, Tile and OSB materials which are ideal for roof sheathing systems. The tile roofing can range from simple single-family residences till an expansive range covering large commercial buildings. If you have started with tile roof installation, these are the steps that can help you ensure that it is done accurately for optimal performance and minimum chances of fallback.

Ensure Proper Roof Ventilation: In case you have hired tile roofing company to lay down your roof, put forth a condition that the ventilation must be ensured as per the Building Codes. To conduct an inspection in this regard, see if the tiles have a minimum net free ventilation area of 960 square inches over a spread of 1,000 square feet on the entire ceiling area. Also, take into account the vent air exhausts which are installed in bathrooms, kitchens, along with vent pipes which run through the roof cavity. Voice against a setting that allows direct air exhaust into the roof attic.

Tighten the Panels Properly: During the roof installation focus on the spacing between the panels keeping a minimum of 0.131-inch by 2-1/2-inch spaced area between nails on center as well as at panel ends and edges. Also, ensure to position panel using temporary fasteners at corners. Ensure to install fasteners at one end of the panel along with taking steps to remove temporary fasteners at the corners. Post this, work towards installing intermediate fasteners, taking the lead from the panel edge. Always ensure that the tile roofing is done efficiently while fastening the panels in a row across the width taking forward this sequence to the entire panel length. This way the homeowners can be assured that internal stress does not accumulate inside the panels, keeping the roof study and intact for long.

Ensure to cover Sheathing with Shingle Underlayment: This must be done at all costs unless the manufacturer recommends against the same. The sheathing must be covered with shingle underlayment felt which limits the roof’s exposure to weather. Make sure that the underlayment is compliance with roofing manufacturer’s recommendations. In the case of shingle roofing, always ensure to remove wrinkles and keep the surface flat before installing fiberglass or asphalt shingles on the surface

Comply with Manufacturer Recommendations / Guidelines while Installing Shingles: Be it new shingle roof installation or tile roof repair, it is important that for every roof type the manufacturer’s guidelines are complied with. In the case of installing asphalt or fiberglass shingles, it is bets to postpone shingle installation for as long as feasible. This will help the roof sheathing to adjust to humidity as well as extreme moisture conditions. As an installation and appearance tip, always stick your choice with heavier weight shingles or the ones that are laminated or textured. It is due to the fact that such roofing materials help in masking the surface imperfections along with minimizing shingle ridging risk.


Leave a Reply

Your email address will not be published. Required fields are marked *